Huawei Quidway S6500 Series - Display Rip Routing

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-3
<Quidway> display rip
RIP is running
public net VPN-Instance
Checkzero is on Default cost : 1
Summary is on Preference : 100
Traffic-share-across-interface is off
Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
No peer router
Network :
10.0.0.0
Table 2-1 Description of information generated by the command display rip
Field Description
RIP is running RIP is active
Checkzero is on Enable zero field checking
Default cost : 1 The default route cost is 1
Summary is on Routes are summarized automatically
Preference : 100 The preference of RIP is 100
Traffic-share-across-interface
is off
Traffic sharing across RIP interfaces is disabled
Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
Three timers of RIP
No peer router
No destination address of a transmission is
specified
Network :10.0.0.0 Enable RIP on network segment 202.38.168.0
2.1.4 display rip routing
Command
display rip routing
View
Any view
Parameter
None