Huawei Quidway S6500 Series - Reset Isis Peer

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-30
Parameter
none
Description
Using reset isis all command, you can reset all the IS-IS data structures.
By default, IS-IS data structure will not be cleared.
This command is used when LSPs need refreshing immediately. For example, after
area-authentication-mode and domain-authentication-mode commands are
executed, the old LSP still remain on the router. This command can be used to clear
them.
For the related commands, see area-authentication-mode,
domain-authentication-mode.
Example
# Reset all the IS-IS data structures.
<Quidway> reset isis all
4.1.36 reset isis peer
Syntax
reset isis peer system-id
View
User view
Parameter
system-id: Specifies the system ID of IS-IS neighbor.
Description
Using reset isis peer command, you can reset the specified IS-IS peer.
By default, the IS-IS neighbor will not be cleared.
This command is used when you want to reconfigure a certain neighbor.
Example
# Clear the IS-IS neighbor whose system ID is 0000.0c11.1111.
<Quidway> reset isis peer 0000.0c11.1111