Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 1 File System Management Commands
Huawei Technologies Proprietary
1-12
1.2 Configuration File Management Commands
1.2.1 display current-configuration
Syntax
display current-configuration [ controller | interface interface-type
[ interface-number ] | configuration [ configuration ] | vlan [ vlan-id ] ] [ | { begin |
exclude | include } regular-expression ]
View
Any view
Parameter
controller: View the configuration information of controllers.
interface: View the configuration information of interfaces.
interface-type: Type of the interface, may be Aux, GigabitEthernet, NULL,
Vlan-interface, M-Ethernet, | ( Matching output ).
interface-number: Number of the interface.
configuration configuration: View the pre-positive and post-positive configuration
information. The value of configuration is the key word of the configuration, such as:
z acl-adv: View the configuration information of advanced ACL.
z ospf: View the configuration information of OSPF.
z system: View the configuration information of sysname.
z timerange: View the configuration information of time range.
z user-interface: View the configuration information of user-interface.
vlan-id: The VLAN ID.
|: Filter the configuration information to be output via regular expression.
begin: Begin with the line that matches the regular expression.
exclude: Exclude lines that match the regular expression.
include: Include lines that match the regular expression.
regular-expression: Define the regular expression.
Description
Using display current-configuration command, you can display the currently
effective configuration parameters of the switch.
By default, if some running configuration parameters are the same with the default
operational parameters, they will not be displayed.
If a user needs to authenticate whether the configurations are correct after finishing a
set of configuration, the display current-configuration command can be used to
To Next Page
Loading...
Need help?
General
