Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 3 Device Management Commands
Huawei Technologies Proprietary
3-19
Description
Using set backboard view command, you can configure backboard view.
Salience III series engines do not support this command.
Example
# Set backboard view.
[Quidway] set backboard view 1
Configuration of System Back Board Mode
Default settings are in square brackets '[]'.
The new configuration will be as following:
|Slot No. lBrd Type |Slot Band Width |Brd Available
| 1 |NONE | 8G |NO
| 2 |NONE | 8G |NO
| 3 |NONE | 4G |NO
| 4 |LS81FT48 | 4G |YES
| 5 |NONE | 4G |NO
| 6 |NONE | 4G |NO
Are you sure the configuration is correct, continue?[Y/N]
3.1.25 temperature-limit
Syntax
temperature-limit slot-num down-value up-value
undo temperature-limit slot-num
View
User view, system view
Parameter
slot-num: Physical card number.
down-value: Lower temperature limit.
up-value: Upper temperature limit.
Description
Using temperature-limit command, you can configure temperature limit. Using undo
temperature-limit command, you can restore temperature limit to default value.
Example
# Set the lower and upper temperature limit of card 0.
<Quidway> temperature-limit 0 10 75