Huawei Quidway S6500 Series - Reset Multicast Forwarding-Table

Command Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches Chapter 3 Multicast Common Configuration Commands
Huawei Technologies Proprietary
3-7
undo multicast routing-enable
View
System view
Parameter
None
Description
Using multicast routing-enable command, you can enable IP multicast routing. Using
undo multicast routing-enable command, you can disable IP multicast routing.
By default, IP multicast routing is disabled.
The system will not forward any multicast packet when IP multicast routing is disabled.
For the related commands, see pim dm and pim sm.
Example
# Enable IP multicast routing.
<Quidway> system-view
[Quidway] multicast routing-enable
3.1.8 reset multicast forwarding-table
Syntax
reset multicast forwarding-table [ statistics ] { all | { group-address [ mask
{ group-mask | group-mask-length } ] | source-address [ mask { source-mask |
source-mask-length } ] | incoming-interface interface-type interface-number } * }
View
User view
Parameter
statistics: If it is selected, the system clears the statistic information of MFC forward
entries. Otherwise, the system clears MFC forward entries.
all: All MFC forward entries.
group-address: Specifies group address.
group-mask: Specifies Mask of group address
group-mask-length: Specifies mask length of group address.
source-address: Specifies source address.
source-mask: Specifies mask of source address.