Command Manual - Reliability
Quidway S6500 Series Ethernet Switches Chapter 1 VRRP Configuration Commands
Huawei Technologies Proprietary
1-10
Description
Use the vrrp vrid track command to configure tracking of the interface.
Use the undo vrrp vrid track command to stop tracking the interface.
VRRP interface track expends the backup function, which thereby can be implemented
not only when the switch fails, but also when a network interface is down. You can use
this command to track or stop tracking an interface or all the interfaces. After the
configuration of the interface tracking, the priority of the switch will be reduced, if the
tracked interface turns down. Accordingly, some other switch in the virtual router will
have the comparatively highest priority and become the new master, thereby
implementing the backup function. The IP address owner does not allow the
configuration of interface tracking.
Note:
z The monitored physical port may be contained in the VLAN of the VLAN interface
the backup group belongs to.
z When the switch is an IP address owner, its interfaces cannot be tracked.
z If a tracked port becomes “up”, the priority level of the corresponding switch will
resume automatically.
z Each virtual router can track up to eight ports.
Example
# Configure to track interface vlan-interface1 on interface vlan-interface2; and when the
vlan-interface1 becomes down, the priority of the virtual router 1 on interface
vlan-interface2 reduces 50.
[Quidway-vlan-interface2] vrrp vrid 1 track vlan-interface 1 reduced 50
1.1.11 vrrp vrid virtual-ip
Syntax
vrrp vrid virtual-router-ID virtual-ip virtual-address
undo vrrp vrid virtual-router-ID [ virtual-ip virtual-address ]
View
VLAN interface view
To Next Page
Loading...
Need help?
General
