Command Manual - Port
Quidway S6500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-1
Chapter 1 Ethernet Port Configuration Commands
1.1 Ethernet Port Configuration Commands
1.1.1 broadcast-suppression
Syntax
broadcast-suppression { ratio | bandwidth bandwidth | pps pps }
undo broadcast-suppression
View
Ethernet port view
Parameter
ratio: Specifies the maximum bandwidth ratio of the broadcast traffic allowed on
Ethernet port, ranging form 1 to 100. By default, the value is 100. The smaller the ratio
is, the smaller the broadcast traffic is permitted.
bandwidth bandwidth: Specifies the maximum bandwidth of the broadcast traffic on
Ethernet port. It ranges from 1 to 100 for 100Mbit/s port, from 1 to 1000 for 1000Mbit/s
port in Mbit/s.
pps pps: Specifies the maximum packets per second of the broadcast traffic.
z For 100M Ethernet port, ranging from 1 to 148,810 pps.
z For 1000M Ethernet port, ranging from 1 to 262,143pps.
Description
Using broadcast-suppression command, you can configure the broadcast traffic size
enabled on current port. Using undo broadcast-suppression command, you can
restore the default broadcast traffic enabled on current port.
By default, all broadcast traffic is allowed to pass through, that is, no broadcast
suppression will be performed.
Once the broadcast traffic exceeds the value set by the user, the system will discard
some broadcast to ensure network service so that the traffic ratio of broadcast is
maintained in a proper range.
The configuration of the suppression mode on the port will overwrite the previously
configured mode.
To Next Page
Loading...
Need help?
General
