Huawei Quidway S6500 Series Command Manual

Command Manual - STP
Quidway S6500 Series Ethernet Switches Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-21
1.1.22 stp interface transmit-limit
Syntax
stp interface interface-list transmit-limit packetnum
undo stp interface interface-list transmit-limit
View
System view
Parameter
interface-list: Ethernet port list, containing multiple Ethernet ports and expressed as
interface _list = { { interface_type interface_num | interface_name } [ to { interface_type
interface_num | interface_name } ] }&<1-10>. For detail descriptions of interface_type,
interface_num and interface_name parameters, refer to the corresponding descriptions
in Port Command Manual. &<1-10> means that the preceding parameters can be
entered up to 10 times.
packetnum: Specifies the amount limit to the transmitted packets, ranging from 1 to 255
(expressed as a counter value without any units). By default, the transmission limit on
every port is 3.
Description
Using stp interface transmit-limit command, you can configure an amount limit to the
configuration BPDU transmitted via a port during the Hello Time in system view. Using
undo stp interface transmit-limit command, you can restore the default limit in
system view.
The larger the value is, the more packets can be transmitted in a time unit, yet the more
switch resources will be occupied. With a moderate value, the amount of the BPDUs
transmitted during Hello Time via every port can be limited and MSTP will not occupy
too many bandwidth resources when the network topology flaps.
For the related command, see stp transmit-limit.
Example
# Set a limit of 5 to the packets transmitted via Ethernet2/0/3 in system view.
[Quidway] stp interface Ethernet2/0/3 transmit-limit 5
1.1.23 stp loop-protection
Syntax
stp loop-protection
undo stp loop-protection

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English