Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 3 Device Management Commands
Huawei Technologies Proprietary
3-18
By default, the timing reboot switch function is disabled.
 Note:
The precision of switch timer is 1 minute. The switch will reboot in one minute when
time comes to the specified rebooting point.
Two formats can be used to set the waiting delay of timing reboot switch, namely the
format of "hour: minute" and the format of "absolute minutes". But the total minutes
should be no more than 30×24×60 minutes, or 30 days.
After this command is configured, the system will prompt you to input confirmation
information. Only after the "Y" or the "y" is entered can the configuration be valid. If
there is related configuration before, it will be covered directly.
Moreover, after the schedule reboot at command is configured, and the system time is
adjusted by the clock command, the original schedule reboot at parameter will
become invalid.
For the related command, see reboot, schedule reboot at, undo schedule reboot,
display schedule reboot.
Example
# Configure the switch to be restarted after 88 minutes (the current time is 21:32).
<Quidway> schedule reboot delay 88
Reboot system at 17:54 2005/04/06(in 1 hours and 28 minutes)
confirm?[Y/N]:y
<Quidway>
%Apr 6 16:26:38 2005 S6506R CMD/5/REBOOT:
aux0: schedule reboot parameters at 16:26:34 2005/04/06. And system will reboot
at 17:54:2005 04/06/2005.
3.1.24 set backboard view
Syntax
set backboard view value
View
System view
Parameter
value: indicates value of backboard view, ranging from 0 to 5.