Huawei Quidway S6500 Series Command Manual

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 5 BGP Configuration Commands
Huawei Technologies Proprietary
5-3
View
system view
Parameter
as-number: The specified local AS number.
Description
Using bgp command, you can enable BGP and enter the BGP view. Using undo bgp
command, you can disable BGP.
By default, the system does not run BGP.
This command is used to enable and disable BGP as well as to specify the local AS
number of BGP.
Example
# Enable BGP.
[Quidway] bgp 100
[Quidway-bgp]
5.1.3 compare-different-as-med
Syntax
compare-different-as-med
undo compare-different-as-med
View
BGP view
Parameter
none
Description
Using compare-different-as-med command, you can enable comparison of MED
values from different AS neighboring routes when determining the best route. Using
undo compare-different-as-med command, you can disable the comparison.
By default, it is disabled to compare the MED attribute values from the routing paths of
different AS peers.
If there are several routes available to one destination address, the route with smaller
MED parameter can be selected as the final route item.
Do not use this command unless it is determined that the same IGP and routing
selection mode are adopted by different autonomous systems.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English