Huawei Quidway S6500 Series - Static Route Configuration Commands; Delete Static-Routes All

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
0错误！表格结果无效。
Huawei Technologies Proprietary
1-15
State: <Int ActiveU Retain Unicast>
Age: 20:17:41 Cost: 0/0
**Destination: 1.1.1.1 Mask: 255.255.255.255
Protocol: #DIRECT Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 20:17:42 Cost: 0/0
**Destination: 2.2.2.0 Mask: 255.255.255.0
Protocol: #DIRECT Preference: 0
*NextHop: 2.2.2.1 Interface: 2.2.2.1(Vlan-interface2)
State: <Int ActiveU Retain Unicast>
Age: 20:08:05 Cost: 0/0
First, display statistics of the whole routing table and then output detailed information of
every route entry in turn. The meaning of route status is shown in Table 1-2, and the
statistics of routing table is shown in the following table.
Table 1-5 Description of information generated by the command display ip
routing-table verbose
Field Description
Holddown Number of held-down routes
Delete Number of deleted routes
Hidden Number of hidden routes
1.2 Static Route Configuration Commands
1.2.1 delete static-routes all
Syntax
delete static-routes all
View
System view
Parameter
None
Description
Using the delete static-routes all command, you can delete all the static routes.
The system will request your confirmation before it deletes all the configured static
routes.