Huawei Quidway S6500 Series Command Manual

Command Manual - Getting Started
Quidway S6500 Series Ethernet Switches Chapter 1 Logging in Ethernet Switch Commands
Huawei Technologies Proprietary
1-19
When users log into the switch, the commands they can use depend jointly on the user
level settings and the command level settings on the user interface. If the two types of
settings differ,
z For the users using AAA/RADIUS/HWTACACS authentication, the commands
they can use are determined by the user level settings. For example, if a use is set
to level 3 and the command level on the VTY 0 user interface is level 1, he or she
can only use the commands of level 3 or lower when logging into the switch from
the VTY 0 user interface.
z For the users using RSA public key authentication, the commands they can use
are determined by the command level settings on the user interface.
By default, ping, tracert, and telnet are at visit level (0); display and debugging are at
monitoring level (1); all the configuration commands are at system level (2); and FTP,
TFTP and commands for file system operations are at management level (3).
Example
# Configure the user zbr to use commands at level 0 after logon.
[Quidway] local-user zbr
[Quidway-luser-zbr] service-type telnet level 0
# Quit the system and logs on with username “zbr” again. Now only the commands at
level 0 are listed on the terminal.
[Quidway] quit
<Quidway> ?
User view commands:
language-mode Specify the language environment
ping Send echo messages
quit Exit from current command view
super Privilege current user a specified priority level
telnet Establish one TELNET connection
tracert Trace route function
undo Undo a command or set to its default status
1.1.25 set authentication password
Syntax
set authentication password { cipher | simple } password
undo set authentication password
View
User interface view

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English