Huawei Quidway S6500 Series - Garp Timer Leaveall; Reset Garp Statistics

Command Manual - VLAN
Quidway S6500 Series Ethernet Switches Chapter 2 GARP/GVRP Configuration Commands
Huawei Technologies Proprietary
2-4
2.1.4 garp timer leaveall
Syntax
garp timer leaveall timer_value
undo garp timer leaveall
View
System view
Parameter
timer_value: Value of GARP leaveall timer in centisecond, ranging from 65 to 32765.
The step is 5 centiseconds. The value of Leaveall timer should be greater than the
value of Leave timer. By default, the value of LeaveAll timer is 1000 centiseconds, i.e.
10s.
Description
Using garp timer leaveall command, you can configure GARP leaveall timer. Using
undo garp timer leaveall command, you can restore the default value.
After every GARP application entity is started, the LeaveAll timer will be started
simultaneously. The GARP application entity will send LeaveAll message after the timer
times out to make other application entities re-register all attribute information on
themselves. Then, the LeaveAll timer is started and the new cycle begins.
For the related command, see display garp timer.
Example
# Set GARP LeaveAll timer as 1s.
[Quidway] garp timer leaveall 100
2.1.5 reset garp statistics
Syntax
reset garp statistics [ interface interface-list ]
View
User view
Parameter
interface-list: Specifies a list of Ethernet ports, on which the GARP statistics information
will be cleared, expressed as interface-list = { { interface_type interface_num |
interface_name } [ to { interface_type interface_num | interface_name } ] }&<1-10>.
interface_type is interface type, interface_num is interface number and interface_name