Huawei Quidway S6500 Series - Reset Multicast Routing-Table

Command Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches Chapter 3 Multicast Common Configuration Commands
Huawei Technologies Proprietary
3-8
source-mask-length: Specifies mask length of source address.
incoming-interface: Specifies incoming interface for the forward entry.
interface-type interface-number: Interface type and interface number.
Description
Using reset multicast forwarding-table command, you can clear MFC forwarding
entries or statistic information of MFC forwarding entries.
You can type in source address first and group address after in the command, as long
as they both are valid addresses. The system prompts error information if you type in
invalid addresses.
For the related commands, see reset pim routing-table, reset multicast
routing-table and display multicast forwarding-table.
Example
# Clear the forwarding entry with address of 225.5.4.3 from the MFC forwarding table.
<Quidway> reset multicast forwarding-table 225.5.4.3
# Clear statistic information of the forwarding entry with address of 225.5.4.3 from the
MFC forwarding table.
<Quidway> reset multicast forwarding-table statistics 225.5.4.3
3.1.9 reset multicast routing-table
Syntax
reset multicast routing-table { all | { group-address [ mask { group-mask |
group-mask-length } ] | source-address [ mask { source-mask | source-mask-length } ]
| incoming-interface interface-type interface-number } * }
View
User view
Parameter
all: All route entries in the core multicast routing table.
group-address: Specifies group address.
group-mask: Specifies Mask of group address
group-mask-length: Specifies mask length of group address.
source-address: Specifies source address.
source-mask: Specifies mask of source address.
source-mask-length: Specifies mask length of source address.
incoming-interface: Specifies incoming interface for the forward entry.