Huawei Quidway S6500 Series - Section 10

Command Manual - Reliability
Quidway S6500 Series Ethernet Switches Table of Contents
Huawei Technologies Proprietary
i
Table of Contents
Chapter 1 VRRP Configuration Commands ...............................................................................1-1
1.1 VRRP Configuration Commands....................................................................................... 1-1
1.1.1 debugging vrrp ........................................................................................................ 1-1
1.1.2 display vrrp.............................................................................................................. 1-1
1.1.3 reset vrrp statistics .................................................................................................. 1-3
1.1.4 vrrp authentication-mode ........................................................................................ 1-4
1.1.5 vrrp method ............................................................................................................. 1-5
1.1.6 vrrp ping-enable ...................................................................................................... 1-6
1.1.7 vrrp vrid preempt-mode........................................................................................... 1-7
1.1.8 vrrp vrid priority........................................................................................................ 1-8
1.1.9 vrrp vrid timer .......................................................................................................... 1-8
1.1.10 vrrp vrid track......................................................................................................... 1-9
1.1.11 vrrp vrid virtual-ip................................................................................................. 1-10
Chapter 2 HA Configuration Commands ....................................................................................2-1
2.1 HA Configuration Commands............................................................................................ 2-1
2.1.1 display switchover state .......................................................................................... 2-1
2.1.2 slave auto-update config......................................................................................... 2-1
2.1.3 slave restart............................................................................................................. 2-2
2.1.4 slave switchover...................................................................................................... 2-3
2.1.5 slave update configuration ...................................................................................... 2-3