Huawei Quidway S6500 Series Command Manual

Command Manual - Network Protocol
Quidway S6500 Series Ethernet Switches Chapter 7 IPX Configuration Commands
Huawei Technologies Proprietary
7-7
Note that after the undo ipx enable command is executed, the IPX configurations are
not recoverable with the ipx enable command.
Example
# Enable IPX.
[Quidway] ipx enable
7.1.6 ipx encapsulation
Syntax
ipx encapsulation [ dot2 | dot3 | ethernet-2 | snap ]
undo ipx encapsulation
View
VLAN interface view
Parameter
dot2: Sets the encapsulation format to Ethernet_802.2.
dot3: Sets the encapsulation format to Ethernet_802.3.
ethernet-2: Sets the encapsulation format to Ethernet_II.
snap: Sets the encapsulation format to Ethernet_SNAP.
Description
Using the ipx encapsulation command, you can configure an IPX frame
encapsulation format on the current VLAN interface. Using the undo ipx
encapsulation command, you can restore the encapsulation format to the default.
By default, the IPX frame encapsulation format is Ethernet_802.3 (dot3).
Example
# Set the IPX frame encapsulation format to Ethernet_II on VLAN interface 1.
[Quidway-Vlan-interface1] ipx encapsulation ethernet-2
7.1.7 ipx netbios-propagation
Syntax
ipx netbios-propagation
undo ipx netbios-propagation
View
VLAN interface view

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English