Huawei Quidway S6500 Series Command Manual

Command Manual - Reliability
Quidway S6500 Series Ethernet Switches Chapter 1 VRRP Configuration Commands
Huawei Technologies Proprietary
1-5
This command is used to configure the authentication type and key for all the VRRP
virtual routers on an interface. As defined in the protocol, all the virtual routers on an
interface shall use the same authentication type and key. And all the members joining
the same virtual router shall also use the same authentication type and key.
The authentication key is case sensitive.
Example
# Specify the authentication type and key for a VRRP virtual router.
[Quidway-vlan-interface2] vrrp authentication-mode simple huawei
1.1.5 vrrp method
Syntax
vrrp method { real-mac | virtual-mac }
undo vrrp method
View
System view
Parameter
real-mac: Uses the real MAC address of the interface to match the virtual IP address of
the virtual router in VRRP backup.
virtual-mac: Uses the virtual MAC address of the interface to match the virtual IP
address of the virtual router in VRRP backup.
Description
Use the vrrp method command to set correspondence between the MAC address and
the virtual IP address of the virtual router: matching the real or virtual MAC address with
the virtual IP address.
Use the undo vrrp method command to reset the correspondence to the default value.
By default, the switch matches the virtual MAC address with the virtual IP address of
the virtual router.
Due to the chips installed, some switches support matching one IP address of a routing
interface to multiple MAC addresses. Then you may configure correspondence
between the virtual IP address of the virtual router and the real/virtual MAC address.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English