Huawei Quidway S6500 Series - Chapter 5 BGP Configuration Commands; BGP Configuration Commands; Aggregate

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 5 BGP Configuration Commands
Huawei Technologies Proprietary
5-1
Chapter 5 BGP Configuration Commands
 Note:
When an Ethernet switch runs a routing protocol, it can perform the router functions.
Router that is referred to in the following and its icon represent a generalized router or
an Ethernet switch running routing protocols. To improve readability, this will not be
described in the other parts of the manual.
5.1 BGP Configuration Commands
 Note:
For the commands defining routing policies in BGP, refer to the “Routing Policy" of the
next chapter.
5.1.1 aggregate
Syntax
aggregate address mask [ as-set | attribute-policy route-policy-name |
detail-suppressed | origin-policy route-policy-name | suppress-policy
route-policy-name ]*
undo aggregate address mask [ as-set | attribute-policy route-policy-name |
detail-suppressed | origin-policy route-policy-name | suppress-policy
route-policy-name ]*
View
BGP view
Parameter
address: Address of the aggregated route.
mask: Network mask of the aggregated route.
as-set: Create a route with segment of AS_SET.
detail-suppressed: Only advertise the aggregated route.