Huawei Quidway S6500 Series Command Manual

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-17
enable each interface on which the IS-IS process runs. The IS-IS protocol is actually
enabled upon the completion of these configurations.
 Note:
Only one IS-IS routing process can be started on one router.
For the related commands, see isis enable, network-entity.
Example
# Start an IS-IS routing process, in which the system ID is 0000.0000.0002 and the area
ID is 01.0001.
[Quidway] isis
[Quidway-isis] network-entity 01.0001.0000.0000.0002.00
4.1.19 isis authentication-mode
Syntax
isis authentication-mode { simple | md5 } password [ { level-1 | level-2 } [ ip | osi ] ]
undo isis authentication-mode { simple | md5 } password [ { level-1 | level-2 } [ ip |
osi ] ]
View
VLAN interface view
Parameter
simple: Configure to transmit the password in plain text.
md5: Configure to transmit the password encrypted with MD5 algorithm.
password: If the authentication is in the simple mode, the password must be in plain
text. If the authentication is in the md5 mode, the password can be either in cipher text
or in plain text, and it will be displayed in a cipher text form in a length of 24 characters
when display current-configuration command is executed. A plain text password is a
sequential character string of no more than 16 characters, for example, h3c. The length
of an cipher text must be 24 characters, for example, _(TT8F]Y\5SQ=^Q`MAF4<1!!.
level-1: Configure authentication password for L1.
level-2: Configure authentication password for L2.
ip: If this item is configured, the system checks the configuration of the corresponded
field of the IP in LSP.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English