Huawei Quidway S6500 Series - Refresh Bgp

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 5 BGP Configuration Commands
Huawei Technologies Proprietary
5-48
View
BGP view
Parameter
cluster-id: Specify the cluster ID of the route reflector with the range from 1 to
4294967295.
address: Used as the interface address of the route reflector’s cluster ID.
Description
Using reflector cluster-id command, you can configure the cluster ID of the route
reflector. Using undo reflector cluster-id command, you can delete the cluster ID of
the route reflector.
By default, each route reflector uses its Router ID as the cluster ID.
For the related commands, see reflect between-clients, peer reflect-client.
Example
# Set the cluster ID of the route reflector as 80.
[Quidway-bgp] reflector cluster-id 80
5.1.59 refresh bgp
Syntax
refresh bgp { all | peer-address | group group-name } { import | export }
View
User view
Parameter
all: Reset all the connections with BGP.
peer-address: Reset connection with a specified BGP peer.
group-name: Reset connection with a specified BGP peer group.
import: Refresh the routes learned from the peers
export: Refresh routes advertised to the peers.
Description
Using refresh bgp peer-address command, you can refresh general BGP routes.
When BGP routing policy changes, it is required to re-compute associated route
information. This command can refresh general BGP routes.