Huawei Quidway S6500 Series Command Manual

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-7
View
RIP view
Parameter
None
Description
Using host-route command, you can control the RIP to accept the host route. Using
undo host-route command, you can reject the host route.
By default, RIP accepts the host route.
In some special cases, RIP receives a great number of host routes in the same network
segment. These routes cannot help the path searching much but occupy a lot of
resources. In this case, the undo host-route command can be used to reject a host
route.
Example
# Configure RIP to reject a host route.
[Quidway-rip] undo host-route
2.1.8 import-route
Syntax
import-route protocol [ cost value | route-policy route-policy-name ]*
undo import-route protocol
View
RIP view
Parameter
protocol: Specify the source routing protocol to be imported by RIP. At present, RIP can
import the following routes: direct, bgp, ospf, ospf-ase, ospf-nssa , isis and static.
value: Cost value of the route to be imported, ranging from 1 to 16.
route-policy route-policy-name: Configure to import the route matching the condition
of the specified Route-policy only. The length of route-policy-name parameter ranges
from 1 to 16 character string.
Description
Using import-route command, you can import the routes of other protocols into RIP.
Using undo import-route command, you can cancel the routes imported from other
protocols.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English