Huawei Quidway S6500 Series Command Manual

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-14
Area 0.0.0.0:
Authtype: none Flags: <>
SPF scheduled: <>
Interface: 201.1.1.4 (Vlan-interface1)
Cost: 1 State: DR Type: Broadcast
Priority: 1
Designated Router: 201.1.1.4
Backup Designated Router: 201.1.1.3
Timers: Hello 10, Dead 40, Poll 40, Retransmit 5, Transmit Delay 1
Table 3-3 Description of information generated by the command display ospf brief
Field Description
RouterID Router ID of the router
Border Router
Border routers for connection to the area, including
autonomous system border router (ASBR) and area
border router (ABR)
spf-schedule-interval Interval of SPF schedule
Authtype Authentication type of OSPF
Routing preference
Routing preference of OSPF. The internal route of OSPF
includes intra/inter area route, and its default routing
preference is 10. While that of the external route of OSPF
is 150 by default
Default ASE
parameters
Default ASE parameters of OSPF, including metric, type
and tag
SPF computation
count
SPF computation count since OSPF is enabled
Area Count Areas for connection to this router
Nssa Area Count Number of NSSA areas
SPF scheduled SPF scheduled (flag)
Interface Interface name belonging to this area
Cost Cost of routes
State State information
Type Network type of OSPF interface
Priority Priority
Designated Router IP address of designated router (DR)
Backup Designated
Router
IP address of backup designated router (BDR)

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English