Command Manual - Reliability
Quidway S6500 Series Ethernet Switches Chapter 1 VRRP Configuration Commands
Huawei Technologies Proprietary
1-2
View
Any view
Parameter
interface: Displays VRRP information of the specified VLAN interface.
vlan-interface interface-num: Interface name.
statistics: Displays VRRP statistics.
virtual-router-ID: VRRP virtual router ID, ranging from 1 to 255.
Description
Use the display vrrp command to view the information about the VRRP state or VRRP
statistics. If the interface name and virtual router ID are not specified, the state
information about all the virtual routers on the switch will be displayed. If only the
interface name is specified, the state information about all the virtual routers on this
interface will be displayed. If the interface name and virtual router ID are specified, the
state information about the specified virtual router on this interface will be displayed.
If the interface name and virtual router ID are not specified, the statistics about all the
virtual routers on the switch will be displayed. If only the interface name is specified, the
statistics about all the virtual routers on this interface will be displayed. If the interface
name and virtual router ID are specified, the statistics about the specified virtual router
on this interface will be displayed.
Example
# Display the statistics about the virtual router on VLAN-interface 1 of the switch.
[Quidway-Vlan-interface1] display vrrp statistics
[Quidway-Vlan-interface1] display vrrp statistics
Interface : Vlan-interface10
VRID : 1
CheckSum Errors : 0 Version Errors : 0
VRID Errors : 0 Advertisement Interval Errors : 0
IP TTL Errors : 0 Auth Failures : 0
Invalid Auth Type : 0 Auth Type Mismatch : 0
Packet Length Errors : 0 Address List Errors : 0
Become Master : 2 Priority Zero Pkts Rcvd : 0
Advertise Rcvd : 0 Priority Zero Pkts Sent : 1
Invalid Type Pkts Rcvd : 0
To Next Page
Loading...
Need help?
General
