Huawei Quidway S6500 Series Command Manual

Command Manual - VLAN
Quidway S6500 Series Ethernet Switches Chapter 1 VLAN Configuration Commands
Huawei Technologies Proprietary
1-13
protocol-index: Protocol index value, ranging from 0 to 6. If not specified, it is
automatically allocated by the system.
protocol-end: Protocol index end value, ranging from 0 to 6, and must be greater than
the value of protocol-index.
all: All protocol indexes.
Description
Using the protocol-vlan command, you can configure a certain protocol type for the
specified VLAN. Using the undo protocol-vlan command, you can cancel this
configuration.
Note that the format of mode llc dsap ff ssap ff is the same as that of ipx raw, and the
system first matches ipx raw, so the configuration of vlan-type protocol mode llc
dsap ff ssap ff does not function.
For the related commands, see display protocol-vlan vlan.
Example
# Specify VLAN 3 to be based on IP protocol.
[Quidway-vlan3] protocol-vlan ip
# Specify VLAN 5 to be based on the 123.34.56.0 network segment.
[Quidway-vlan5] protocol-vlan ip 123.34.56.0

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English