Agilent Technologies InfiniiVision 3000 X-Series

1044 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
35 Obsolete and Discontinued Commands
:CHANnel<n>:INPut (see
page 1053)
:CHANnel<n>:IMPedance
(see page 267)
:CHANnel<n>:PMODe (see
page 1054)
none
:DISPlay:CONNect (see
page 1055)
:DISPlay:VECTors (see
page 308)
:DISPlay:ORDer (see
page 1056)
none
:ERASe (see page 1057):DISplay:CLEar (see page 303)
:EXTernal:PMODe (see
page 1058)
none
FUNCtion1, FUNCtion2 :FUNCtion Commands (see
page 323)
ADD not included
:FUNCtion:SOURce (see
page 1059)
:FUNCtion:SOURce1 (see
page 352)
Obsolete command has ADD,
SUBTract, and MULTiply
parameters; current command
has GOFT parameter.
:FUNCtion:VIEW (see
page 1060)
:FUNCtion:DISPlay (see
page 333)
:HARDcopy:DESTination (see
page 1061)
:HARDcopy:FILename (see
page 1062)
:HARDcopy:FILename (see
page 1062)
:RECall:FILename (see
page 600)
:SAVE:FILename (see
page 600)
:HARDcopy:GRAYscale (see
page 1063)
:HARDcopy:PALette (see
page 371)
:HARDcopy:IGColors (see
page 1064)
:HARDcopy:INKSaver (see
page 363)
:HARDcopy:PDRiver (see
page 1065)
:HARDcopy:APRinter (see
page 360)
:MEASure:LOWer (see
page 1066)
:MEASure:DEFine:THResholds
(see page 413)
MEASure:DEFine:THResholds
can define absolute values or
percentage
:MEASure:SCRatch (see
page 1067)
:MEASure:CLEar (see
page 411)
:MEASure:TDELta (see
page 1068)
:MARKer:XDELta (see
page 386)
Obsolete Command Current Command Equivalent Behavior Differences