Agilent Technologies InfiniiVision 3000 X-Series - Page 165

Common (*) Commands 5
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 165
*CLS (Clear Status)
(see page 1138)
Command Syntax
*CLS
The *CLS common command clears the status data structures, the
device-defined error queue, and the Request- for-OPC flag.
See Also • "Introduction to Common (*) Commands" on page 163
• "*STB (Read Status Byte)" on page 182
• "*ESE (Standard Event Status Enable)" on page 166
• "*ESR (Standard Event Status Register)" on page 168
• "*SRE (Service Request Enable)" on page 180
• ":SYSTem:ERRor" on page 855
NOTE
If the *CLS command immediately follows a program message terminator, the output queue
and the MAV (message available) bit are cleared.