172 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
5 Common (*) Commands
*OPC (Operation Complete)
(see page 1138)
Command Syntax
*OPC
The *OPC command sets the operation complete bit in the Standard Event
Status Register when all pending device operations have finished.
Query Syntax
*OPC?
The *OPC? query places an ASCII "1" in the output queue when all
pending device operations have completed. The interface hangs until this
query returns.
Return Format
<complete><NL>
<complete> ::= 1
See Also • "Introduction to Common (*) Commands" on page 163
• "*ESE (Standard Event Status Enable)" on page 166
• "*ESR (Standard Event Status Register)" on page 168
• "*CLS (Clear Status)" on page 165
To Next Page
Loading...
