To Next Page

To Previous Page

Root (:) Commands 6

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 193

:AUToscale

(see page 1138)

Command Syntax

:AUToscale

:AUToscale [<source>[,..,<source>]]

<source> ::= CHANnel<n> for the DSO models

<source> ::= {DIGital<d> | POD1 | POD2 | CHANnel<n>} for the

MSO models

<n> ::= 1 to (# analog channels) in NR1 format

<d> ::= 0 to (# digital channels - 1) in NR1 format

The <source> parameter may be repeated up to 5 times.

The :AUToscale command evaluates all input signals and sets the correct

conditions to display the signals. This is the same as pressing the

[Auto Scale] key on the front panel.

If one or more sources are specified, those specified sources will be

enabled and all others blanked. The autoscale channels mode (see

":AUToscale:CHANnels" on page 196) is set to DISPlayed channels. Then,

the autoscale is performed.

When the :AUToscale command is sent, the following conditions are

affected and actions are taken:

• Thresholds.

• Channels with activity around the trigger point are turned on, others

are turned off.

• Channels are reordered on screen; analog channel 1 first, followed by

the remaining analog channels, then the digital channels 0- 15.

• Delay is set to 0 seconds.

• Time/Div.

The :AUToscale command does not affect the following conditions:

• Label names.

• Trigger conditioning.

The :AUToscale command turns off the following items:

• Cursors.

• Measurements.

• Math waveforms.

• Reference waveforms.

• Zoomed (delayed) time base mode.

Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series