Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

194 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
6 Root (:) Commands
For further information on :AUToscale, see the User's Guide.
See Also • "Introduction to Root (:) Commands" on page 190
• ":AUToscale:CHANnels" on page 196
• ":AUToscale:AMODE" on page 195
Example Code
' AUTOSCALE - This command evaluates all the input signals and sets
' the correct conditions to display all of the active signals.
myScope.WriteString ":AUToscale" ' Same as pressing Auto Scale key.
See complete example programs at: Chapter 40, “Programming Examples,”
starting on page 1147

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English