Root (:) Commands 6
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 219
:RUN
(see page 1138)
Command Syntax
:RUN
The :RUN command starts repetitive acquisitions. This is the same as
pressing the Run key on the front panel.
See Also • "Introduction to Root (:) Commands" on page 190
• ":SINGle" on page 221
• ":STOP" on page 223
Example Code
' RUN_STOP - (not executed in this example)
' - RUN starts the data acquisition for the active waveform display.
' - STOP stops the data acquisition and turns off AUTOSTORE.
' myScope.WriteString ":RUN" ' Start data acquisition.
' myScope.WriteString ":STOP" ' Stop the data acquisition.
See complete example programs at: Chapter 40, “Programming Examples,”
starting on page 1147
To Next Page
Loading...
