Agilent Technologies InfiniiVision 3000 X-Series - Voltage Measurements

Root (:) Commands 6
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 221
:SINGle
(see page 1138)
Command Syntax
:SINGle
The :SINGle command causes the instrument to acquire a single trigger of
data. This is the same as pressing the Single key on the front panel.
See Also • "Introduction to Root (:) Commands" on page 190
• ":RUN" on page 219
• ":STOP" on page 223