Agilent Technologies InfiniiVision 3000 X-Series - Set Up Network Printer Connections

290 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
12 :DIGital<d> Commands
The DIGital subsystem commands control the viewing, labeling, and
positioning of digital channels. They also control threshold settings for
groups of digital channels, or pods.
Reporting the Setup
Use :DIGital<d>? to query setup information for the DIGital subsystem.
Return Format
The following is a sample response from the :DIGital0? query. In this case,
the query was issued following a *RST command.
:DIG0:DISP 0;THR +1.40E+00;LAB 'D0';POS +0
NOTE
These commands are only valid for the MSO models.