To Next Page

To Previous Page

:DIGital<d> Commands 12

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 291

:DIGital<d>:DISPlay

(see page 1138)

Command Syntax

:DIGital<d>:DISPlay <display>

<d> ::= 0 to (# digital channels - 1) in NR1 format

<display> ::= {{1 | ON} | {0 | OFF}}

The :DIGital<d>:DISPlay command turns digital display on or off for the

specified channel.

Query Syntax

:DIGital<d>:DISPlay?

The :DIGital<d>:DISPlay? query returns the current digital display setting

for the specified channel.

Return Format

<display> ::= {0 | 1}

See Also • "Introduction to :DIGital<d> Commands" on page 289

• ":POD<n>:DISPlay" on page 525

• ":CHANnel<n>:DISPlay" on page 266

• ":VIEW" on page 225

• ":BLANk" on page 198

• ":STATus" on page 222

NOTE

This command is only valid for the MSO models.

Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series