308 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
13 :DISPlay Commands
:DISPlay:VECTors
(see page 1138)
Command Syntax
:DISPlay:VECTors <vectors>
<vectors> ::= {1 | ON}
The only legal value for the :DISPlay:VECTors command is ON (or 1). This
specifies that lines are drawn between acquired data points on the screen.
Query Syntax
:DISPlay:VECTors?
The :DISPlay:VECTors? query returns the vectors setting.
Return Format
<vectors><NL>
<vectors> ::= 1
See Also • "Introduction to :DISPlay Commands" on page 298
To Next Page
Loading...
