:FUNCtion Commands 16
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 327
• SQUare
• ABSolute — Absolute Value
• LOG — Common Logarithm
• LN — Natural Logarithm
• EXP — Exponential (e
x
)
• TEN — Base 10 exponential (10
x
)
• Filters:
• LOWPass — Low pass filter — The FREQuency:LOWPass command
sets the - 3 dB cutoff frequency.
• HIGHpass — High pass filter — The FREQuency:HIGHpass command
sets the - 3 dB cutoff frequency.
Filters operate on a single analog channel source or on a g(t) function
that is the addition, subtraction, or multiplication of analog channel
sources (specified by the GOFT commands).
• Visualizations:
• MAGNify — Operates on a single analog channel source or on a g(t)
function that is the addition, subtraction, or multiplication of analog
channel sources (specified by the GOFT commands).
• TRENd — Measurement trend — Operates on a single analog channel
source. The TRENd:MEASurement command selects the measurement
whose trend you want to measure.
• BTIMing — Chart logic bus timing — Operates on a bus made up of
digital channels. The BUS:YINcrement, BUS:YORigin, and BUS:YUNit
commands specify function values.
• BSTate — Chart logic bus state — Operates on a bus made up of
digital channels. The BUS:YINcrement, BUS:YORigin, and BUS:YUNit
commands specify function values. The BUS:CLOCk and BUS:SLOPe
commands specify the clock source and edge.
The SOURce1, DISPlay, RANGe, and OFFSet (or REFerence) commands
apply to any function.
Reporting the Setup
Use :FUNCtion? to query setup information for the FUNCtion subsystem.
Return Format
The following is a sample response from the :FUNCtion? queries. In this
case, the query was issued following a *RST command.
:FUNC:OPER ADD;DISP 0;SOUR1 CHAN1;SOUR2 CHAN2;RANG +8.00E+00;OFFS
+0.0E+00;:FUNC:GOFT:OPER ADD;SOUR1 CHAN1;SOUR2 CHAN2
To Next Page
Loading...
Need help?
General
