Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

What's New 1
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 35
Discontinued
Commands
:STATus (see page 222) You can now use the WMEMory<r> source parameter to view
the display status of a reference waveform location.
:VIEW (see page 225) You can now use the WMEMory<r> source parameter to turn on
the display of a reference waveform location.
Command Differences
Discontinued Command Current Command Equivalent Comments
:POWer:SIGNals:CYCLes :POWer:SIGNals:CYCLes:HAR
Monics (see page 565)
:POWer:SIGNals:CYCLes:QUA
Lity (see page 566)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SIGNals:DURation :POWer:SIGNals:DURation:EF
Ficiency (see page 567)
:POWer:SIGNals:DURation:M
ODulation (see page 568)
:POWer:SIGNals:DURation:ON
OFf:OFF (see page 569)
:POWer:SIGNals:DURation:ON
OFf:ON (see page 570)
:POWer:SIGNals:DURation:RIP
Ple (see page 571)
:POWer:SIGNals:DURation:TR
ANsient (see page 572)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SIGNals:VMAXimum :POWer:SIGNals:VMAXimum:I
NRush (see page 575)
:POWer:SIGNals:VMAXimum:
ONOFf:OFF (see page 576)
:POWer:SIGNals:VMAXimum:
ONOFf:ON (see page 577)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SIGNals:VSTeady :POWer:SIGNals:VSTeady:ON
OFf:OFF (see page 578)
:POWer:SIGNals:VSTeady:ON
OFf:ON (see page 579)
:POWer:SIGNals:VSTeady:TRA
Nsient (see page 580)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SLEW:VALue none Slew rate values are now
displayed using max and min
measurements of a
differentiate math function
signal.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English