Agilent Technologies InfiniiVision 3000 X-Series

s1
375
Agilent InfiniiVision 3000 X-Series Oscilloscopes
Programmer's Guide
18
:LISTer Commands
Introduction to
:LISTer
Commands
The LISTer subsystem is used to turn on/off the serial decode Lister
display and return data from the Lister display.
Table 90 :LISTer Commands Summary
Command Query Options and Query Returns
n/a :LISTer:DATA? (see
page 376)
<binary_block> ::=
comma-separated data with
newlines at the end of each row
:LISTer:DISPlay {{OFF
| 0} | {SBUS1 | ON |
1} | {SBUS2 | 2} |
ALL} (see page 377)
:LISTer:DISPlay? (see
page 377)
{OFF | SBUS1 | SBUS2 | ALL}
:LISTer:REFerence
<time_ref> (see
page 378)
:LISTer:REFerence?
(see page 378)
<time_ref> ::= {TRIGger |
PREVious}