Agilent Technologies InfiniiVision 3000 X-Series

s1
529
Agilent InfiniiVision 3000 X-Series Oscilloscopes
Programmer's Guide
24
:POWer Commands
These :POWer commands are available when the DSOX3PWR power
measurements and analysis application is licensed and enabled.
Table 96 :POWer Commands Summary
Command Query Options and Query Returns
:POWer:DESKew (see
page 534)
n/a n/a
:POWer:EFFiciency:APP
Ly (see page 535)
n/a n/a
:POWer:ENABle {{0 |
OFF} | {1 | ON}} (see
page 536)
:POWer:ENABle? (see
page 536)
{0 | 1}
:POWer:HARMonics:APPL
y (see page 537)
n/a n/a
n/a :POWer:HARMonics:DATA
? (see page 538)
<binary_block> ::=
comma-separated data with
newlines at the end of each row
:POWer:HARMonics:DISP
lay <display> (see
page 539)
:POWer:HARMonics:DISP
lay? (see page 539)
<display> ::= {TABLe | BAR | OFF}
n/a :POWer:HARMonics:FAIL
count? (see page 540)
<count> ::= integer in NR1 format
:POWer:HARMonics:LINE
<frequency> (see
page 541)
:POWer:HARMonics:LINE
? (see page 541)
<frequency> ::= {F50 | F60 |
F400}
n/a :POWer:HARMonics:POWe
rfactor? (see
page 542)
<value> ::= Class C power factor
in NR3 format
n/a :POWer:HARMonics:RUNC
ount? (see page 543)
<count> ::= integer in NR1 format
:POWer:HARMonics:STAN
dard <class> (see
page 544)
:POWer:HARMonics:STAN
dard? (see page 544)
<class> ::= {A | B | C | D}