Agilent Technologies InfiniiVision 3000 X-Series

664 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
27 :SBUS<n> Commands
CAN Id specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:ID
and:SBUS<n>:CAN:TRIGger:PATTern:ID:MODE commands.
CAN Data specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:DATA
command.
CAN Data Length Code is set by the
:SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth command.
Query Syntax
:SBUS<n>:CAN:TRIGger?
The :SBUS<n>:CAN:TRIGger? query returns the current CAN trigger on
condition.
Return Format
<condition><NL>
<condition> ::= {SOF | DATA | ERR | IDD | IDE | IDR | ALL | OVER | ACK}
Errors • "- 241, Hardware missing" on page 1099
See Also • "Introduction to :SBUS<n> Commands" on page 629
• ":SBUS<n>:MODE" on page 633
• ":SBUS<n>:CAN:TRIGger:PATTern:DATA" on page 665
• ":SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth" on page 666
• ":SBUS<n>:CAN:TRIGger:PATTern:ID" on page 667
• ":SBUS<n>:CAN:TRIGger:PATTern:ID:MODE" on page 668
• ":SBUS<n>:CAN:SIGNal:DEFinition" on page 661
• ":SBUS<n>:CAN:SOURce" on page 662