s1
777
Agilent InfiniiVision 3000 X-Series Oscilloscopes
Programmer's Guide
28
:SEARch Commands
Control the event search modes and parameters for each search type. See:
• "General :SEARch Commands" on page 778
• ":SEARch:EDGE Commands" on page 782
• ":SEARch:GLITch Commands" on page 785 (Pulse Width search)
• ":SEARch:RUNT Commands" on page 792
• ":SEARch:TRANsition Commands" on page 797
• ":SEARch:SERial:A429 Commands" on page 802
• ":SEARch:SERial:CAN Commands" on page 808
• ":SEARch:SERial:FLEXray Commands" on page 814
• ":SEARch:SERial:I2S Commands" on page 820
• ":SEARch:SERial:IIC Commands" on page 826
• ":SEARch:SERial:LIN Commands" on page 833
• ":SEARch:SERial:M1553 Commands" on page 839
• ":SEARch:SERial:SPI Commands" on page 843
• ":SEARch:SERial:UART Commands" on page 847
To Next Page
Loading...
