Agilent Technologies InfiniiVision 3000 X-Series

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 9
*RCL (Recall) 175
*RST (Reset) 176
*SAV (Save) 179
*SRE (Service Request Enable) 180
*STB (Read Status Byte) 182
*TRG (Trigger) 184
*TST (Self Test) 185
*WAI (Wait To Continue) 186
6 Root (:) Commands
:ACTivity 191
:AER (Arm Event Register) 192
:AUToscale 193
:AUToscale:AMODE 195
:AUToscale:CHANnels 196
:AUToscale:FDEBug 197
:BLANk 198
:DIGitize 199
:MTEenable (Mask Test Event Enable Register) 201
:MTERegister[:EVENt] (Mask Test Event Event Register) 203
:OPEE (Operation Status Enable Register) 205
:OPERegister:CONDition (Operation Status Condition Register) 207
:OPERegister[:EVENt] (Operation Status Event Register) 209
:OVLenable (Overload Event Enable Register) 211
:OVLRegister (Overload Event Register) 213
:PRINt 215
:PWRenable (Power Event Enable Register) 216
:PWRRegister[:EVENt] (Power Event Event Register) 218
:RUN 219
:SERial 220
:SINGle 221
:STATus 222
:STOP 223
:TER (Trigger Event Register) 224
:VIEW 225
7 :ACQuire Commands
:ACQuire:COMPlete 229
:ACQuire:COUNt 230
:ACQuire:MODE 231
:ACQuire:POINts 232