Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

920 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

31 :TRIGger Commands

You can only specify an edge on one channel. When an edge is specified,

the :TRIGger:PATTern:QUALifier does not apply.

Query Syntax

:TRIGger:PATTern?

The :TRIGger:PATTern? query returns the pattern string, edge source, and

edge.

Return Format

See Also • "Introduction to :TRIGger Commands" on page 877

• ":TRIGger:PATTern:FORMat" on page 921

• ":TRIGger:PATTern:QUALifier" on page 924

• ":TRIGger:MODE" on page 886

NOTE

The optional <edge_source> and <edge> parameters should be sent together or not at all.

The edge can be specified in the ASCII <string> parameter. If the edge source and edge

parameters are used, they take precedence.

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series