Agilent Technologies InfiniiVision 3000 X-Series

:WAVeform Commands 32
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 975
The :WAVeform:POINts:MODE? query returns the current points mode.
Setting the points mode will affect what data is transferred. See the
discussion above.
Return Format
<points_mode><NL>
<points_mode> ::= {NORMal | MAXimum | RAW}
See Also • "Introduction to :WAVeform Commands" on page 961
• ":WAVeform:DATA" on page 969
• ":ACQuire:POINts" on page 232
• ":WAVeform:VIEW" on page 988
• ":WAVeform:PREamble" on page 976
• ":WAVeform:POINts" on page 972
• ":TIMebase:MODE" on page 867
• ":ACQuire:TYPE" on page 239
• ":ACQuire:COUNt" on page 230