Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F Revision B
APPENDIX Fax Unit System 667
300 064 0x3040
Receiving the fax is rejected due to the DM prevention
function
Not used --- --- --- --- ---
300 065 0x3041
The product failed to read the original while
performing manual transmitting
The next original was not
set in time
Try the operation again *3 External error code 50H: Forced stop Transmitting a fax is finished
300 066 0x3042
When transmitting, image data conversion was not
made in time
MFP data transferring
failure
External error code 50H: Forced stop Transmitting a fax is finished
300 100 0x3100
The product could not detect normal lines within a
minute after starting to receive the image data in G3
mode
Not used --- --- --- --- ---
300 101 0x3101
Decoding data without RTC at the time of ECM
reception caused the MN8604 to be disabled to perform
decode process
Not used --- --- --- --- ---
300 102 0x3102
Number of lines for received one page exceeded
acceptable level (more than 65535 lines)
Not used --- --- --- --- ---
300 103 0x3103
Abnormal termination of MN86064 Not used
300 104 0x3104
MN8604 failed to process commands within a
prescribed time period
Not used --- --- --- --- ---
300 105 0x3105
File pointer that is used for writing/reading in
encoding/decoding process caused an error
There is something wrong
with the fax board or the
S/W
Replace the fax board --- Transmitting failure 50H: Forced stop Transmitting a fax is finished
300 106 0x3106
The number of lines that indicate the processed lines in
encoding/decoding process is 0
There is something wrong
with the fax board or the
S/W
Replace the fax board --- Transmitting failure 50H: Forced stop Transmitting a fax is finished
300 107 0x3107
Monitor timer for encoding/decoding by MN86064
became time-out
Not used --- --- --- --- ---
300 108 0x3108
Target file is empty in decoding/encoding process Not used --- --- --- --- ---
300 109 0x3109
During MMR decoding, MN86064 decode error
occurred
Not used --- --- --- --- ---
300 110 0x310A
During decoding JBIG data at MN86064, BIH/over
flow error was detected
Not used --- --- --- --- ---
300 111 0x310B
During decoding JBIG data at MN86064, an end
marker error was detected
Not used --- --- --- --- ---
300 112 0x310C
During decoding JBIG data at MN86064, a YD error
was detected
Not used --- --- --- --- ---
300 113 0x310D
During decoding JBIG data at MN86064, an abort
marker error was detected
Not used --- --- --- --- ---
300 114 0x310E
During decoding JBIG data, BIH operated abnormally Not used --- --- --- --- ---
Table 7-23. Operator Call Error
External
error code
Internal
Code
Description Cause Remedies
Panel
Display
(reference)
Report Display
Trigger for
Stopping
Operation
Notification Message
MAIN SUB

Epson AcuLaser CX11 Specifications

General

Brand	Epson
Model	AcuLaser CX11
Category	All in One Printer
Language	English