Command Manual – Information Center
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Information Center Configuration
Commands
Huawei Technologies Proprietary
1-16
default: Defaults the settings of all modules.
channel-number: Number of information channel to be used.
channel-name: Channel name, by default, the name of channel 0 to channel 9 is (in
turn) console, monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6,
channel7, channel8, channel9.
log: Specifies to output log information.
trap: Specifies to output trap information.
debug: Specifies to output debugging information.
level: Specifies an information severity level.
severity: Information severity level. The information with severity level greater than this
level will not be output.
state: Sets the information state.
state: Can be on or off.
Description
Use the info-center source command to specify the information source in the
information center and the output direction.
Use the undo info-center source command to cancel the configuration of information
source and output direction.
This command can be used for filtering of log, trap or debugging information. For
example, it can control information output from the IP module to any direction. You can
configure to output information with severity higher than “warning” to the log host, and
information with severity higher than “informational” to the log buffer. You can also
configure to output trap information to the log host at the same time.
The info-center source command determines the output direction according to
channel name or channel number. Each output direction is assigned with a default
information channel at present, as shown in
Table 1-4.
Table 1-4 Default information channel
Output direction Information channel name
Console console
Monitor terminal monitor
Log host loghost
Log buffer logbuffer
Trap buffer trapbuffer
SNMP snmpagent
To Next Page
Loading...
Need help?
General