Command Manual - HWPing
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 HWPing Commands
Huawei Technologies Proprietary
1-3
Example
# Use the display hwping results command to display the test result of the test group
whose administrator name is “administrator” and operation tag is “icmp”.
<Quidway> display hwping results administrator icmp
HWPing entry(admin administrator, tag icmp) test result:
Destination ip address:1.1.1.99
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 2/5/2
Square-Sum of Round Trip Time: 66
Last complete test time: 2000-4-2 7:59:54.7
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
Table 1-1 Description on the fields of the display hwping results command
Field Description
Destination ip address Destination IP address
Send operation times Number of times the operation is sent
Receive response times
Number of times of the successful test
operations
Min/Max/Average Round Trip Time Smallest/biggest/average round-trip time
Square-Sum of Round Trip Time The square sum of the round trip time
Last complete test time Time of the last successful test
SD Maximal delay
Maximal delay from the source to the
destination
DS Maximal delay
Maximal delay from the destination to the
source
Packet lost in test Packet lost ratio in the test.
Disconnect operation number
Number of times of disconnections by the
opposite side
To Next Page
Loading...
