Huawei Quidway S3900 Series - Page 208

Command Manual – Port Security & Port Binding
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Port Security Commands
Huawei Technologies Proprietary
1-3
Ethernet1/0/1 is link-down
Port mode is noRestriction
NeedtoKnow mode is needtoknowonly
Intrusion mode is disableport
Max mac-address num is 100
Stored mac-address num is 0
Authorization is permit
(Any display that follows is omitted.)
Table 1-1 Description on the fields of the display port-security command
Field Description
Equipment port security is enabled
The port security function is enabled on
the switch.
AddressLearn trap is Enabled
The sending of address-learning trap
information is enabled.
Intrusion trap is Enabled
The sending of intrusion-detection trap
information is enabled.
Dot1x logon trap is Enabled
The sending of 802.1x user logon
(authentication success) trap
information is enabled.
Dot1x logoff trap is Enabled
The sending of 802.1x user logoff trap
information is enabled.
Dot1x logfailure trap is Enabled
The sending of 802.1x user
authentication failure trap information is
enabled.
RALM logon trap is Enabled
The sending of RALM logon trap
information is enabled.
RALM logoff trap is Enabled
The sending of RALM logoff trap
information is enabled.
RALM logfailure trap is Enabled
The sending of RALM logfailure trap
information is enabled.
Vlan id assigned is NULL The delivered VLAN ID is Null.
Disableport Timeout: 20 s
The temporary port-disabling time is 20
seconds.
OUI value The OUI value
Ethernet1/0/1 is link-down
The link state of the port Ethernet 1/0/1
is "down".
Port mode is Userlogin
The security mode of the port is
Userlogin.
NeedtoKnow mode is disabled The NTK mode is disabled.