Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-25
Use the display ospf peer brief command to display the brief information, including
router ID, interface, and state, about every OSPF peer.
Use the display ospf peer statistics command to display the statistics of every OSPF
peer, namely, the number of peers in various states in every area.
Example
# Display the information about OSPF peer.
<Quidway> display ospf peer
OSPF Process 1 with Router ID 1.1.1.1
Neighbors
Area 0.0.0.0 interface 10.153.17.88(Vlan-interface1)'s neighbor(s)
RouterID: 2.2.2.2 Address: 10.153.17.89
State: Full Mode: Nbr is Master Priority: 1
DR: 10.153.17.89 BDR: 10.153.17.88
Dead timer expires in 31s
Neighbor has been up for 01:14:14
Table 3-10 Description on the fields of the display ospf peer command
Field Description
RouterID Router ID of neighbor router
Address
Address of the interface, through which
neighbor router communicates with the
router
State State of adjacency relation
Mode
Master/Slave mode formed by
negotiation in exchanging DD packet
Priority Priority of DR/BDR for neighbor election
DR IP address of the interface of elected DR
BDR
IP address of the interface of elected
BDR
Dead timer expires in 31s
If no hello packet is received from the
peer within this interval, the peer will be
considered to be invalid.
Neighbor has been up for 01:14:14 Time of neighbor connection
# Display the brief information about every peer.
<Quidway> display ospf peer brief
OSPF Process 1 with Router ID 1.1.1.1
Neighbor Brief Information
Area 0.0.0.1:
To Next Page
Loading...
