Huawei Quidway S6500 Series - Page 44

Command Manual - Port
Quidway S6500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-4
Description
Using display interface command, you can view the configuration information on the
port.
If the port type and number are not specified when displaying the port information, the
information of all the ports will be displayed. If only the port type is specified, all the
information of the ports of this type will be displayed. If both port type and port number
are specified, the information of the designated port will be displayed.
Example
# Display configuration information of Ethernet1/0/1.
<Quidway> display interface ethernet1/0/1
Ethernet1/0/1 current state : UP
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
00e0-fc00-0010
The Maximum Transmit Unit is 1500
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 1536
Broadcast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Last 300 seconds input: 0 packets/sec 0 bytes/sec
Last 300 seconds output: 0 packets/sec 0 bytes/sec
Input(total): 0 packets, 0 bytes
- broadcasts, - multicasts
Input(normal): 0 packets, 0 bytes
0 broadcasts, 0 multicasts
Input: 0 input errors, 0 runts, 0 giants, 0 throttles, 0 CRC
0 frame, - overruns, - aborts, - ignored, - parity errors
Output(total): 0 packets, 0 bytes
- broadcasts, - multicasts, - pauses
Output(normal): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures