Agilent Technologies InfiniiVision 3000 X-Series - Page 1047

Obsolete and Discontinued Commands 35
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 1047
DISPlay:GRID none
DISPLay:LINE none
DISPlay:PIXel none
DISPlay:POSition none
DISPlay:ROW none
DISPlay:TEXT none
FUNCtion:MOVE none
FUNCtion:PEAKs none
HARDcopy:ADDRess none Only parallel printer port is
supported. GPIB printing not
supported
MASK none All commands discontinued,
feature not available
:POWer:SIGNals:CYCLes :POWer:SIGNals:CYCLes:HAR
Monics (see page 565)
:POWer:SIGNals:CYCLes:QUA
Lity (see page 566)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SIGNals:DURation :POWer:SIGNals:DURation:EF
Ficiency (see page 567)
:POWer:SIGNals:DURation:M
ODulation (see page 568)
:POWer:SIGNals:DURation:ON
OFf:OFF (see page 569)
:POWer:SIGNals:DURation:ON
OFf:ON (see page 570)
:POWer:SIGNals:DURation:RIP
Ple (see page 571)
:POWer:SIGNals:DURation:TR
ANsient (see page 572)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SIGNals:VMAXimum :POWer:SIGNals:VMAXimum:I
NRush (see page 575)
:POWer:SIGNals:VMAXimum:
ONOFf:OFF (see page 576)
:POWer:SIGNals:VMAXimum:
ONOFf:ON (see page 577)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SIGNals:VSTeady :POWer:SIGNals:VSTeady:ON
OFf:OFF (see page 578)
:POWer:SIGNals:VSTeady:ON
OFf:ON (see page 579)
:POWer:SIGNals:VSTeady:TRA
Nsient (see page 580)
This command was separated
into several other commands
for specific types of power
analysis.
Discontinued Command Current Command Equivalent Comments